Isuzu — Engine stopping
Operation · Engine operation
From a Isuzu owner's manual — check it applies to your exact model before use.
Browse Isuzu generators & specs →
Before you start
- Leaving key in DRIVE position after engine stops will discharge batteries.
Procedure
- Make sure all control levers are in NEUTRAL.
- Cool down at low idle speed for three minutes.
- Pull engine stop knob to full to cut fuel feed.
- If stopping device equipped, turn starter switch key to OFF.
- Turn starter switch key to OFF and switch off battery switch if equipped.
Specs & values
- Cool down: three minutes at low idle
Source: Isuzu owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.