Isuzu — DKV-14D Compressor (Magnetic Clutch) Removal
Repair & overhaul · Compressor drive plate / clutch
From a Isuzu service manual — check it applies to your exact model before use.
Browse Isuzu generators & specs →
Procedure
- Remove drive plate bolt using drive plate holder J-7624.
- Remove drive plate using drive plate puller J-33944-A and forcing screw J-33944-4.
- Remove shim(s).
- Remove snap ring using snap ring pliers.
- Remove pulley assembly using pulley puller pilot J-38424, pulley puller J-8433 and pulley puller leg J-24092-2.
- Loosen screw and disconnect coil lead wire connector.
- Loosen three screws and remove field coil.
Tools required
- J-7624 drive plate holder Amazon
- J-33944-A drive plate puller Amazon
- J-33944-4 forcing screw Amazon
- J-38424 pulley puller pilot Amazon
- J-8433 pulley puller Amazon
- J-24092-2 pulley puller leg Amazon
- Snap ring pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Isuzu service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.