International — Preparation of J1939 Wire for Connection
Repair & overhaul · J1939 data link wire
From a International service manual — check it applies to your exact model before use.
Procedure
- Strip back (view C) outer shield 3 1/8 in. (76 mm).
- Strip (view A) green wire and yellow wire 1/4 in. (6.35 mm) being careful not to cut individual strands.
- Re-twist all three wires if they have separated.
- Sleeve drain wire (view B) may be soldered to aid in sleeving.
- Install terminals on green and yellow wire ends, and crimp.
- The 1/4" heat shrink tube (view D) will be shrunk later after the wires have been inserted into the crimp connector.
Source: International service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.