International — Instrument Cluster - Adding Gauges

Installation · Electronic Gauge Cluster (EGC)

From a International service manual — check it applies to your exact model before use.

Procedure

1. Remove EGC shroud from instrument panel.
2. Remove four screws which hold the EGC in place.
3. Tilt the EGC forward to gain access to the back of the EGC.
4. Remove the 12-way connector from the center of the EGC.
5. Remove any additional connectors from the EGC.
6. Remove the back cover from the EGC.
7. Remove the filler plug from desired gauge location.
8. Install gauge in open space and attach jumper; if added to upper position, jumper must connect to the upper connector.
9. Installation of the gauge cluster is the reverse of the removal procedure.

Source: International service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More International repair guides →