International — Installation of Battery Disconnect Switch
Installation
From a International service manual — check it applies to your exact model before use.
Before you start
- Make sure that batteries are disconnected prior to performing any electrical work.
Procedure
- Break into the positive battery cable going from the batteries to the cranking motor and insert disconnect switch into that circuit.
- Insure that adequate electrical insulation is used between the positive battery cable, the switch mounting, and the surrounding area.
- Place boots or covers over the disconnect switch studs to protect the batteries and cables from accidental shorting.
- Do not disturb the direct connections from the battery to the engine or transmission electronics.
- Cover eyelets and studs with dielectric grease to reduce corrosion.
Specs & values
- If a non-OEM switch is used, it must be designed to handle at least 1,000 amp (intermittent duty)
Source: International service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.