International — Fog Light Installation
Installation · Fog lights
From a International service manual — check it applies to your exact model before use.
Before you start
- Turn off ignition switch before starting Procedure to avoid injury.
Procedure
- Install fog lights using hardware included in the kit.
- If there is available switch capacity in Location One, install the fog light control switch in Location one.
- If the Location One switch pack module is fully populated, install a six pack (p/n 3549776C4) in Location Two.
- Additional switch blanks (p/n 3533950C1) may be needed to cover unused switch locations.
- Wire fog lights according to wiring diagram.
- Adding fog lights will require reprogramming the system controller. See local dealer.
Source: International service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.