International — Crimp and Seal Splice Sleeve Installation
Repair & overhaul
From a International service manual — check it applies to your exact model before use.
Before you start
- Use appropriate heat gun. Do not use a match or open flame to heat the sleeve seal.
Procedure
- Cut off the old sleeve or bad section of the wire.
- Remove insulation being careful not to cut any of the wire strands.
- Install the proper sleeve on the wire strands, making sure the ends of the wire hit the stop.
- Hand crimp to the sleeve. Gently tug on the wire to make sure that they are secure.
- Electrically check the sleeve and wire cable for continuity.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- New sleeve minimum 1.5 inches (40 mm) from a connector, clip or another sleeve
Source: International service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.