Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Trigger and Housing.

Ingersoll Rand — Trigger and Housing.

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 8. Install Pin (40) in Housing, securing Reverse Cam and Trigger.
  2. 9. Install Bushing (48) in Housing, pressing flush with counterbore in bottom of motor cavity.
  3. 10. Install Roll Pin (47) in Housing, pressing flush with bottom of motor cavity.
  4. 11. Coat Reverse Valve (36) with the recommended oil and install in Housing, aligning slot in Reverse Valve with Roll Pin (47).
  5. 12. Install Spring (37) in Housing.
  6. 13. Lubricate and install O-Ring (38) in Top Cap (39) and install Cap in Housing, securing Spring (37) and Reverse Valve (36).
  7. 14. Coat Valve Rod (35) with the recommended oil and install in Housing.
  8. 15. Install Spring (34) in Housing, where applicable.
  9. 16. Lubricate and install O-Ring (33) in End Cap (32) and install Cap in Housing, securing Valve Rod and Spring.

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.