Ingersoll Rand — Torque Tube Assembly

Repair & overhaul

From a Ingersoll Rand service manual — check it applies to your exact model before use.

Procedure

1. Install inner support tube (100) in outer support tube (129).
2. Install capscrews (126), nuts (127) and washers (128).
3. Install inner shaft assembly (109-117).
4. Install air cylinder (106).
5. Install capscrews (107), nuts (108) and washers (123).
6. Connect air cylinder connecting clip (114) to attachment plate (117).
7. Install the torque tool in the torque tube.
8. Connect main air supply to regulator at connector (142).
9. Turn on the main supply to the torque tube.
10. Adjust regulator (145) adjustment knob so equal effort is required to raise and lower tube.

Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Ingersoll Rand repair guides →