Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Springs (82) and (83) are loose and may fall out.

Ingersoll Rand — Springs (82) and (83) are loose and may fall out.

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 3. Secure a 1/4” hex wrench in a vise. Then place Bit Holder (100) and clutch assembly on it.
  2. 4. Remove Snap Ring (84). Using a 7/8” wrench, remove Adjustment Nut (85).
  3. 5. Remove Adjustment Washer (86) and Clutch Spring (87).
  4. 6. Remove Retaining Rings (88).

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.