Ingersoll Rand — Direct Drive Attachment Disassembly

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. Unscrew and remove the Screwdriver Housing Assembly (150) - this is a left-hand thread
2. Using a pair of snap ring pliers, reach into the Screwdriver Housing and remove the Bit Holder Retaining Ring (153)
3. Slide the Bit Holder out of the Screwdriver Housing
4. If the Housing Bushing (151) requires replacement, press the Bushing from the Housing toward the Gear Case end
5. Using a pair of snap ring pliers, remove the Bit Holder Retaining Ring near the Bit Retaining Sleeve (155)
6. Remove the Bit Retaining Sleeve from the Bit Holder
7. Using a pointed rod, spiral the Retaining Sleeve Spring (156) from the bit end of the Bit Holder
8. Remove the Bit Retaining Ball (152) from the Bit Holder

Source: manual:16575243ed2b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.