Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Rotor turns without binding.

Ingersoll Rand — Rotor turns without binding.

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 5. Insert Locating Pin (58) or (61) into 0.081” diameter blind hole at bottom of motor cavity in Housing.
  2. 6. Align notches of End Plates and Cylinder and install motor into Housing, aligning notches with Pin.
  3. 7. Lubricate and install O-Ring (59) in End Plate.
  4. 8. Install Spacer (60) in motor.
  5. 9. Install Gearing and Clutch in tool.

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.