Ingersoll Rand — Disassembly of the Reverse Valve

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. Remove the four Handle Bolts (2)
2. Lift the Handle (1) off of the rear of the Motor Housing (30).
3. Discard the Handle Gasket (19) and replace it with a new one when assembling the tool.
4. Use a hooked tool to remove the Reverse Valve (10) from the reverse valve bushing. Set the Reverse Valve aside on a clean bench.
5. Remove and discard the Reverse Valve O-ring (6).
6. Replace it with a new one when assembling the Reverse Valve.
7. Use a flat, thin blade screwdriver to remove the Reverse Lever Retaining Ring (9) and Reverse Lever Spring (7) from the Reverse Lever (8).
8. Remove the Reverse Lever from the Backcap.

Source: manual:04584355ed3c.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.