Ingersoll Rand — Regulator Installation
Installation
From a Ingersoll Rand service manual — check it applies to your exact model before use.
Before you start
- If check valve is installed backwards, cylinder will not function.
Procedure
- Connect connector fitting (36) into the rod end port on the air cylinder.
- Thread check valve (26) into elbow (37).
- Thread elbow (37) into the regulator input.
- Ensure arrow on the check valve (26) points toward the cylinder.
Specs & values
- Check valve arrow must point towards cylinder
Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.