Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Press on outer race of Bearing (69) and press to shoulder or Ring Gear.

Ingersoll Rand — Press on outer race of Bearing (69) and press to shoulder or Ring Gear.

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 2. Press Bearing into Ring Gear.
  2. 3. Coat shafts of spindle with the recommended grease.
  3. 4. Assemble gears to shafts of mating spindle.
  4. 5. Assemble Carrier Assembly to Spindle Assembly of double reduction gearing. Install Spindle(s) and gearing into Ring Gear. Rotate Spindle
  5. and Gears to align gear teeth with splines of Ring Gear.
  6. 6. Thread Ring Gear to tool and tighten with a wrench of flats.
  7. 7. Install Clutch in tool.

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.