Ingersoll Rand — Operational Adjustments
Adjustments · Regulator
From a Ingersoll Rand service manual — check it applies to your exact model before use.
Before you start
- Prior to performing operational adjustments, or servicing, ensure air supply is off and unit is not under load.
Procedure
- Turn adjustment knob (21) counterclockwise until unit stops.
- Attach tool to unit in tool holder and connect coiled air tube.
- Turn on air supply.
- Turn adjustment knob clockwise until tool begins to move.
- Regulator is properly set when equal effort is required to raise and lower the tool.
- Tighten locknut on regulator stem to lock adjustment in position.
Specs & values
- Equal effort required to raise and lower the tool
Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.