Ingersoll Rand — Oiler Adjustment - For Lever Handle Models
Maintenance · Built-in Oiler
From a Ingersoll Rand service manual — check it applies to your exact model before use.
Procedure
- Remove the Arbor Housing Screws (30), Lock Washers (31) and Arbor Housing Gasket (32).
- Remove the Oil Chamber Plug (24) and pour the oil from the oil chamber.
- Using snap ring pliers, remove the Oiler Retainer (18).
- Insert lock ring pliers in the hole of the Oiler Body Assembly (19) and pull out the Oiler Body Assembly.
- With a thin-blade screwdriver, unscrew the Oiler Adjusting Screw (20).
- Using tweezers or a piece of bent wire, remove the Oiler Felts and install a new set.
- Replace the Oiler Adjusting Screw, installing it slightly below flush.
- Replenish the oil supply.
Tools required
- Snap ring pliers Amazon
- Lock ring pliers Amazon
- Thin-blade screwdriver Amazon
- Tweezers or bent wire Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.