Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Lever Throttle

Ingersoll Rand — Lever Throttle

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 1. Secure Air Inlet Adapter (2) in a vise with leather-covered or copper-covered jaws.
  2. 2. Using a strap type wrench, unthread Housing (15).
  3. 3. Remove Spacer (3), Diffuser Washer (4), Exhaust Cap (5), Filler (6), Spring (7) and Valve Assembly (8).
  4. 4. Remove Cap (21) and Spring (19), releasing Valve Stem (18).
  5. 5. Remove Valve Block (10) and Spring (11), releasing valve Assembly (12).
  6. NOTICE
  7. Do not remove or adjust rubber portion of Valve Assemblies (8) and (12), as they are preset at the factory.
  8. 6. Remove O-Ring (13) and Reverse Sleeve (14), releasing Valve Body (17) and Spring (16).
  9. Pistol Grip Housing

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.