Ingersoll Rand — Initial Winch Operating Checks
Operation
From a Ingersoll Rand owner's manual — check it applies to your exact model before use.
Before you start
- Do not allow brake to overheat during new brake band lining run-in.
- Winch motor may stall as drum brake band lining fully engages.
Procedure
- When first running the motor inject a small amount of light oil into the inlet connection for initial lubrication.
- Check oil level in motor, reduction gear assembly and disc brake; top off as required.
- Operate winch in both directions with no load for one to two minutes.
- New brake band lining run-in: operate without load in payout direction while gradually applying brake, allow to slip about one minute.
- Check operation of brakes; adjust if necessary.
- Check operation of limit switches, locking mechanisms and all safety devices when equipped.
- Check foundation mounting fasteners are secure.
- Install drum guard when provided.
Source: Ingersoll Rand owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.