Ingersoll Rand — Initial Operating Checks
Operation · Trolley
From a Ingersoll Rand owner's manual — check it applies to your exact model before use.
Before you start
- Severe injury can be caused by falling under a moving load; push to move the trolley, do not pull
Procedure
- After trolley installation ensure the side plates are vertical
- With hoist installed, verify that hoist is centered below trolley
- Raise a load equal to the lower of the rated capacities of either the trolley or hoist a few inches (cm) off the floor
- Operate the trolley along the entire length of the beam
- Inspect trolley performance when raising, moving and lowering test load(s)
- Trolley must operate smoothly prior to being placed in service for general use
- Check rail stops are securely installed
Source: Ingersoll Rand owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.