Ingersoll Rand — General Lubrication
Maintenance · winch
From a Ingersoll Rand owner's manual — check it applies to your exact model before use.
Before you start
- Pneumatic products use oil to prevent excessive heat buildup and wear that could cause sparks; oil levels must be properly maintained.
Procedure
- Use the recommended grade of oil at all times.
- First oil change should be done after approximately 50 hours of initial operation; thereafter drain and replace per Table 9.
- Inspect removed oil for evidence of internal damage or contamination (metal shavings, dirt, water).
- After product operation, allow oil to settle before topping off.
- Always collect lubricants in suitable containers and dispose of in an environmentally safe manner.
Specs & values
- First oil change after approximately 50 hours
Source: Ingersoll Rand owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.