Ingersoll Rand — General Instructions

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. 1. Always press on the inner ring of a ball-type bearing when installing the bearing on a shaft.
2. 2. Always press on the outer ring of a ball-type bearing when pressing the bearing into a bearing recess.
3. 3. Whenever grasping a tool or part in a vise, always use leather-covered or copper-covered vise jaws. Take extra care with threaded parts and
4. housings.
5. 4. Always clean every part and wipe every part with a thin film of oil before installation.
6. 5. Apply a film of O-ring lubricant to all O-rings before final assembly.
7. 6. Check every bearing for roughness. If an open bearing must be cleaned, wash it thoroughly in a suitable cleaning solution and dry with a clean
8. cloth.
9. 7. Sealed or shielded bearings should never be cleaned. Work grease thoroughly into every open bearing before installation.
10. Assembly of the Motor Housing
11. Lever Throttle

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.