Ingersoll Rand — General Instructions

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. 1. Always press on the inner ring of a ball-type bearing when installing the bearing on a shaft.
2. 2. Always press on the outer ring of a ball-type bearing when pressing the bearing into a bearing recess.
3. 3. Whenever grasping a tool or part in a vise, always use leather-covered or copper-covered vise jaws. Take extra care with threaded parts and

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.