Ingersoll Rand — General Instructions

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. 1. Do not disassemble the tool any further than necessary to replace or repair damaged parts.
2. 2. Whenever grasping a tool or a part in a vise, always use leather-covered or copper-covered vise jaws to protect the surface of the part and help
3. prevent distortion. This is particularly true of threaded members and housings.
4. 3. Do not remove any part which is a press fit in or on a subassembly unless the removal of that part is necessary for repair or replacement.
5. 4. Do not disassemble tool unless you have a complete set of new gaskets and O-rings for replacement.
6. Disassembly of the Clutch
7. The Clutch Housing (105) has left-hand threads.
8. 1. Secure tool in vise with leather-covered or coppercovered jaws, clamping on Inlet Adapter (25). Using a strap type wrench, remove Clutch

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.