Ingersoll Rand — Throttle Lever and Muffler Element Service

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. Secure Exhaust Deflector in copper-covered vise jaws
2. Drive rivet pins inward using pin punch and hammer
3. Remove rivets using needle nose pliers
4. Remove Throttle Lever
5. Remove Throttle Valve Housing Cap Screws with 5/64 hex wrench
6. Remove Throttle Valve Housing and Seal
7. Remove Muffler Elements from Exhaust Deflector
8. Extract Inlet Screen using wooden pencil

Source: manual:16575243ed2b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.