Ingersoll Rand — MHTPA0224).

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. 10. After each piston (455) is assembled to its connecting rod
2. (459), install a gasket (460) and cylinder (453).
3. 11. Slide each cylinder (453) over the piston (455), guiding it
4. carefully over the compression and oil rings. Note that
5. the cylinder has four tapered ears around the skirt of the
6. piston which serve as ring compressors to aid in installa-
7. tion. The cylinder should go into place by tapping
8. lightly. If force is required, there may be an alignment
9. problem which must be corrected before continuing.
10. 12. Secure cylinders (453) to the motor housing (463) by
11. uniformly tightening capscrews (45 1) and lockwashers
12. (452).
13. 13. Remove exhaust cap (469). Install rotary bushing (466)
14. and rotary valve (467) in adapter valve (468). Align the
15. drive pins on the rotary valve (467) with the end of the
16. crank shaft (473). The three drive pins on the crank shaft
17. end of the rotary valve should fit in the holes in the crank
18. shaft without appreciable play. If the holes in the crank
19. shaft are elongated, the crank shaft should be replaced.
20. The drive pins are located so that the rotary valve will

Source: manual:Ingersoll-Rand-FA2-FA2.5-Parts-Operation-and-Maintenenace-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.