Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Remove seals (11) and (12) from brake piston (10).

Ingersoll Rand — Remove seals (11) and (12) from brake piston (10).

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 17. Splined hub removal:
  2. a.
  3. FA2 Winches: Remove splined hub (19) from shaft
  4. (35) followed by retainer ring (32).
  5. b.
  6. FA2.5 Winches: Loosen the capscrew in collar (18)
  7. and slide collar from shaft (35) with the splined hub
  8. (19). Remove retainer ring (32) and spacer (34)
  9. from shaft (35).
  10. 18. Remove retainer ring (36) from the bore of the drum
  11. shaft (41).
  12. 19. Pull shaft and bearing assembly from the drum shaft
  13. (41).
  14. 20. Support the drum (80) and remove capscrews (39) from
  15. the drum shaft (41). Pry drum shaft (41) from the inboard
  16. upright (42).
  17. 21. Remove capscrews (85) and lockwashers (46) which
  18. secure the side rails (82) and (83) to the inboard upright
  19. (42). Drive out dowel pins (87).
  20. 22. Remove inboard upright (42).

Source: manual:Ingersoll-Rand-FA2-FA2.5-Parts-Operation-and-Maintenenace-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.