Ingersoll Rand — Do not remove Bearing (69) and Spacer (68) unless damage is evident.

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. 4. Remove spindle(s) and Gears from Ring Gear.
2. 5. To remove Bearing and Spacer from Ring Gear, press on Spacer (68) from inside splined end of Ring Gear.
3. •
4. •
5. •
6. •

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.