Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Ingersoll Rand›Disassembly of the Motor Housing - Pistol Grip

Ingersoll Rand — Disassembly of the Motor Housing - Pistol Grip

Repair & overhaul

From a Ingersoll Rand service manual — check it applies to your exact model before use.

Before you start

  • Do not remove Roll Pin (47) or Bushing (48) unless damage is evident.

Procedure

  1. Remove End Cap (32) and O-Ring (33), releasing Spring (34) and Valve Rod (35).
  2. Remove Top Cap (39) and O-Ring (38), releasing Spring (37) and Reverse Valve (36).
  3. To remove Roll Pin or Bushing, press thru to reverse valve cavity.
  4. Drive Pin (40) out of Housing to remove Trigger (44) or Button (46), Reverse Cam (43) and Springs (41).
  5. For Models 41TS and 41TP, remove O-Ring (42), releasing Trigger from Reverse Cam (43).
  6. Remove Inlet Adapter (25) and Screen (1).
  7. For Models 41TS and 41TP, remove Spring (26) and Valve Rod (27).
  8. Remove Retaining Ring (29), releasing Screen (30) and Muffler (31).

Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Ingersoll Rand repair guides →