Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Disassembly of the Motor

Ingersoll Rand — Disassembly of the Motor

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. 1. Remove Clutch and Gearing from tool.
  2. 2. Remove Spacer (60) and O-Ring (59).
  3. 3. Tap front edge of housing to remove motor assembly. Locating pin should also come out.
  4. 4. Tap drive end of Rotor (52) with a soft face hammer; motor will come apart.

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.