Ingersoll Rand — Disassembly of the Gearing

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. 1. Remove clutch from tool. Refer to section on Clutch Disassembly.
2. 2. Using a wrench on flats, remove Ring Gear (67) or (81).
3. 3. Remove Snap Ring (71) and Washer (70).
4. NOTICE
5. Keep gears grouped with mating spindle when disassembling double reduction gearing.
6. Do not remove Bearing (69) and Spacer (68) unless damage is evident.
7. 4. Remove spindle(s) and Gears from Ring Gear.
8. 5. To remove Bearing and Spacer from Ring Gear, press on Spacer (68) from inside splined end of Ring Gear.
9. •
10. •
11. •
12. •

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.