Ingersoll Rand — Clutch Housing Disassembly and Bushing Removal

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. Unscrew and remove the Clutch Housing Cap (103) from the Clutch Housing (100)
2. Stand the Clutch Housing on a workbench with the bit end upward
3. Using a hammer and a blunt rod smaller in diameter than the bushing opening, drive the rearmost Bushing out of the Housing by tapping random locations on the face of the Bushing
4. Using a press and supporting the front face of the Housing, press the forward Bushing out the bit end of the Housing

Source: manual:16575243ed2b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.