Ingersoll Rand — Disassembly of the Clutch - Cushion Clutch

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

1. Clamp 1 1/4 inch hex wrench in a vise, then place Bit Holder (89) and Clutch Assembly on it.
2. Remove Snap Ring (71).
3. Remove Adjustment Nut (72) using 7/8 inch wrench.
4. Remove Adjustment Washer (73) and Clutch Spring (74).
5. Remove Snap Ring (75).
6. Slide off Thrust Pad (76), two Thrust Washers (77) and Thrust Bearing (78).
7. Remove Ball Carrier (79) and ten Balls (82).
8. Remove Retaining Ring (86).
9. Slide Jaw back and remove Ball Race (85), sixteen Balls (84). Then remove Driven Jaw (83).
10. Remove O-ring (80) and Push Pin (88) out of Spindle.

Source: manual:47135470ed2b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.