Ingersoll Rand — Auto Shut-Off Clutch Disassembly

Repair & overhaul

From a Ingersoll Rand service manual — check it applies to your exact model before use.

Procedure

1. Clamp 1/4" hex wrench in a vise, then place Bit Holder (107) and Clutch Assembly on it.
2. Remove Snap Ring (71).
3. Remove Adjustment Nut (72) using 7/8" wrench.
4. Remove Adjustment Washer (94) and Clutch Spring (95).
5. Remove Retaining Rings (96).
6. Slide off Guide (97), Spring (98), Ball Sleeve (99) which will release six Balls (104), Thrust Race (100) and Thrust Bearing (78).
7. Remove Thrust Race (101), releasing six Balls (106).
8. Remove Retaining Ring, then rotate Bit Holder to remove twelve Balls (105).
9. Separate Bit Holder (107) and Spindle (103), releasing eleven Balls (105).

Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Ingersoll Rand repair guides →