Ingersoll Rand — Attaching the Tool Holder
Installation
From a Ingersoll Rand service manual — check it applies to your exact model before use.
Procedure
- Attach tool holder to lower flange of Torque Tube using four capscrews, washers, nuts and two clamping plates.
- Loosen capscrews and rotate tool holder until desired position is achieved; retighten capscrews.
- Torque fasteners to 30 Nm (22 ft lbs).
- Install tool in tool holder and tighten capscrews to clamp into position.
Specs & values
- Torque fasteners to 30 Nm (22 ft lbs)
Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.