Ingersoll Rand — Assembly of the Motor Housing - Push to Start and Lever Throttle
Repair & overhaul
From a Ingersoll Rand service manual — check it applies to your exact model before use.
Before you start
- Align ball slot in Valve Body with slot in Housing.
- For Lever Throttle tools, the Throttle Pin (17) should not pull out when Valve Rod (2) is seated properly.
Procedure
- Install Spring (11) and Valve Body (10) in Housing.
- For Lever Throttle models, install Spring (16) and Throttle Pin (17), aligning slot in Throttle Pin with air inlet holes in Housing.
- Install Valve Rod Assembly (2) into Housing so it passes through open slot in Valve Body (10).
- Assemble two Balls (9) into slots of housing and Valve Body (10).
- Install two Fillers (4) to Exhaust Cap (5) or (12).
- Install Exhaust cap to Housing, being certain Balls (9) remain properly positioned in Housing and Reverse Valve.
- Assemble Diffuser Washer (6), Spacer (18) where applicable and Inlet Adapter (7).
- Clean and install Screen (8) in Inlet Adapter.
Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.