Ingersoll Rand — Assembly of the Motor Housing - Lever Throttle
Repair & overhaul
From a Ingersoll Rand service manual — check it applies to your exact model before use.
Before you start
- Install Valve Block (10) with counterbore towards Cap (21).
- Assemble Valve Stem with slot turned to accept Valve Assembly (8).
Procedure
- Install Spring (16) in Housing, securing with Valve Body (17).
- Install Reverse Sleeve (14) and O-Ring (13) in Housing, securing Valve Body.
- Lubricate and install O-Ring (9) in Valve Block (10).
- Install Valve Assembly (12) and Spring (11) in Housing, securing with Valve Block (10).
- Lubricate and install O-Ring (20) in Cap (21).
- Assemble Valve Stem (18) and Spring (19) to Housing, securing with Cap.
- Install Filler (6) and Exhaust Cap (5) in Housing, aligning lever with Valve Stem.
- Install Valve Assembly (8) in Housing, being certain it seats in slot in Valve Stem.
- Install Spring (7) in Housing, securing with Diffuser Washer (4), Spacer (3) and Inlet Adapter (2).
- Clean and install Screen (1) in Inlet Adapter.
Source: Ingersoll Rand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.