Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Lubrication

Ingersoll Rand — Lubrication

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Procedure

  1. Work approximately 8 cc of Ingersoll-Rand Air Impact Wrench Grease No. 105 into the impact mechanism. Coat the Anvil (66, 69, 72 or 79) lightly with grease. Also coat the inside of the HammerCase Bushing (62) with grease. Inject approximately 2 to 4 cc of grease into the Grease Fitting (37, 32).
  2. Use Ingersoll-Rand No. 10 Oil for lubricating the motor. Inject approximately 1 to 2 cc of oil into air inlet (6, 21) before attaching the air hose. Remove the Oil Chamber Plug (2) and fill the oil chamber.

Specs & torque values

  • 8 cc Ingersoll-Rand Air Impact Wrench Grease No. 105
  • 2 to 4 cc grease into Grease Fitting
  • Ingersoll-Rand No. 10 Oil
  • 1 to 2 cc oil into air inlet

Source: manual:04584231ed2b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.