Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›

Ingersoll Rand — 

A Ingersoll Rand service procedure — check it applies to your exact model before use.

Browse Ingersoll Rand generators & specs →

Before you start

  • NOTICE

Procedure

  1. 1. Remove Clutch and Gearing from tool.
  2. 2. Remove Spacer (60) and O-Ring (59).
  3. 3. Tap front edge of housing to remove motor assembly. Locating pin should also come out.
  4. 4. Tap drive end of Rotor (52) with a soft face hammer; motor will come apart.
  5. Bearings are light press fit in End Plate (50) or (57). Bearing (51) is press fit on Rotor.
  6. 5. Remove End Plate and Bearing from Rotor.
  7. Disassembly of the Motor Housing

Source: manual:16575284_ed2_b.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.