Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Using the drill fixture

Hweiteh.Com — Using the drill fixture

A Hweiteh.Com service procedure — check it applies to your exact model before use.

Browse Hweiteh.Com generators & specs →

Procedure

  1. 2. Temporarily attach the drill fixture with two self tap-
  2. ping screws Ø 6 mm (1/4") (A).
  3. Drill all six holes Ø 14 mm (9/16").
  4. NOTE! Drill perpendicularly to the transom.

Source: manual:7746265 Installation Manual D4D6 IPS Aqua Inboard.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.