Hweiteh.Com — Measurement (D) crankshaft centerline (CC) – en-

A Hweiteh.Com service procedure — check it applies to your exact model before use.

Browse Hweiteh.Com generators & specs →

Procedure

1. 3. Install the engine bed drill jig, special tool 889081.
2. NOTE! The notch for positioning the tool. Be careful
3. to ensure that the plate of the tool is correctly fitted to
4. the shield.
5. For information about Jack shaft installation, please
6. refer to the chapter Volvo Penta Jack shaft Instal-
7. lation.

Source: manual:7746265 Installation Manual D4D6 IPS Aqua Inboard.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.