Hweiteh.Com — Twin Engine Installation Setup

A Hweiteh.Com service procedure — check it applies to your exact model before use.

Browse Hweiteh.Com generators & specs →

Procedure

1. Use a carpenter's square to mark the transom.
2. Place a mark at (A), the selected engine centerline distance to port of the transom centerline.
3. Place a second mark (B) at the selected engine centerline distance to starboard of the transom centerline.
4. Make similar measurements from the transom centerline near the bottom of the boat to locate the bottom points.
5. Use a carpenter's square or straight edge to connect both port and starboard transom shield centerline marks.
6. Check the distance at both top and bottom to ensure the transom shield centerlines are equidistant from the transom centerline.
7. Determine the X measurement from the table and mark the heights from the boat bottom to the crankshafts center.

Source: manual:7746265 Installation Manual D4D6 IPS Aqua Inboard.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.