Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Engine Bed Installation

Hweiteh.Com — Engine Bed Installation

A Hweiteh.Com service procedure — check it applies to your exact model before use.

Browse Hweiteh.Com generators & specs →

Before you start

  • The notch for positioning the tool must be carefully aligned. Be careful to ensure that the plate of the tool is correctly fitted to the shield.

Procedure

  1. Build the engine bed in accordance with the specified measurements.
  2. Build in drain channels to allow water to drain to the location of the bilge pump.
  3. Install the engine bed drill jig, special tool 889081.
  4. Cut a recess in the aft and starboard side of engine bed to make space for the exhaust pipe.

Tools required

  • Engine bed drill jig, special tool 889081

Specs & torque values

  • Crankshaft centerline (CC) – engine bed should be 83±8 mm (3.25±0.3")

Source: manual:7746265 Installation Manual D4D6 IPS Aqua Inboard.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.