Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›C = Flat bar, galvanized, approx. 10 mm (0.4")

Hweiteh.Com — C = Flat bar, galvanized, approx. 10 mm (0.4")

A Hweiteh.Com service procedure — check it applies to your exact model before use.

Browse Hweiteh.Com generators & specs →

Procedure

  1. 5. Design the engine bed so that the under side of
  2. the tool plates rest on top of the bed. Build in a flat
  3. bar of galvanized steel, with a thickness of approx.
  4. 10 mm (3/8") and a minimum length of 250 mm (10")
  5. and a minimum width of 80 mm (3").

Source: manual:7746265 Installation Manual D4D6 IPS Aqua Inboard.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.