Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›TO REMOVE THE BELLHOUSING

Hercules — TO REMOVE THE BELLHOUSING

A Hercules service procedure — check it applies to your exact model before use.

Browse Hercules generators & specs →

Procedure

  1. 1. Remove the clutch or power take-off mechanism.
  2. 2. Remove the flywheel. See "Flywheel," Illustration No. 21.
  3. 3. If the engine is in the unit, place suitable supports under the
  4. rear of the crankcase to support the engine.
  5. 4. Remove the rear motor support screws.
  6. 5. Remove the bellhousing attaching stud nuts. See Illustration No. °
  7. 7. This also shows torqueing sequence and pounds torque on nuts.
  8. 6. Pull the bellhousing away from the engine. It may be necessary to
  9. tap the housing with a soft hammer to loosen from the dowels or
  10. gaskets sticking to the block.

Source: manual:HERCULES D4800 Maintenance Manual .pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.