Hercules — To Remove the Bellhousing
Repair & overhaul
From a Hercules owner's manual — check it applies to your exact model before use.
Procedure
- Drain the crankcase oil.
- Remove the clutch or power take-off mechanism and oil pan.
- Remove the flywheel.
- If the engine is in the unit, place suitable supports under the rear of the crankcase.
- Remove the rear motor support screws.
- Remove the bellhousing attaching screws and stud nuts.
- Pull the bellhousing away from the engine; tap with a soft hammer to loosen from dowels or gaskets.
Tools required
- Soft hammer Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Hercules owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.