Hercules — To Install the Bellhousing
Repair & overhaul
From a Hercules owner's manual — check it applies to your exact model before use.
Before you start
- Be sure the hole marked (A) is plugged with the socket head screw.
Procedure
- Install a new oil seal in the bellhousing using sealing compound in the bore before pressing in the seal.
- Cement a new gasket to the bellhousing and allow cement to dry.
- Clean and polish the oil seal surface of the crankshaft; remove nicks or scratches.
- Apply a thin coat of oil soap to the seal and seal surface of the crankshaft.
- Assemble the bellhousing to the engine with dowels entering their holes; secure with screws and nuts.
- Install the rear motor support screws and remove the jack or block.
- Install the flywheel, then the clutch or power take-off mechanism and oil pan.
- Fill the crankcase to the proper level with the correct grade of lubricating oil.
Source: Hercules owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.