Hercules — Stopping the Engine
Operation
From a Hercules owner's manual — check it applies to your exact model before use.
Before you start
- Be sure the proper method of stopping the equipment and engine is fully understood before starting the engine.
Procedure
- If engine operated at or near full load, allow it to run at fast idle (600 to 800 RPM) for one or two minutes after load is removed before stopping.
- If atmospheric temperature is below freezing and no anti-freeze solution is used, drain the complete water circulating system including engine water jackets, water pump, radiator and all water pipes.
- If an anti-freeze solution is used, check with a hydrometer to make sure the solution will not freeze.
- Do not fill batteries with water when shutting down; fill just before starting up for the day's run.
Specs & values
- Fast idle 600 to 800 RPM
Source: Hercules owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.