Home›Repair guides›Hercules›Routine Starting

Hercules — Routine Starting

Operation · engine

From a Hercules service manual covering: D-1500, D-1700, D-2000, D-2300, D-3400, De3000. Check it applies to your exact model before use.

Applies to: Hercules D Series engine

Before you start

  • Do not crank engine for more than 15 seconds at a time.

Procedure

  1. Check adequate fuel supply.
  2. Check lubricating oil level at FULL mark.
  3. Check coolant level in radiator.
  4. Inspect installation for secure parts and no loose tools.
  5. Place throttle control lever at half open position.
  6. Be sure stop control is not in STOP position.
  7. Operate start switch to crank engine.

Specs & values

  • Do not crank engine for more than 15 seconds at a time; allow starting motor to cool 1 minute between cranking intervals.

Source: Hercules service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Hercules repair guides →