Hercules G-1600 — Routine Starting
Operation · engine
For the Hercules G-1600, from the Hercules service manual.
Before you start
- Do not crank the engine for more than 15 seconds at a time.
Procedure
- Check adequate fuel supply.
- Check lubricating oil level above ADD mark on bayonet gauge.
- Check coolant level in radiator.
- Inspect installation for security and no loose tools or parts.
- If ambient temperature is below 32°F refer to cold weather starting instructions.
- Pull out choke control lever; open throttle about one-fourth.
- Turn ignition switch to ON and crank engine to start; do not crank more than 15 seconds at a time.
- Open manual choke slightly until engine runs smoothly; continue opening in increments as engine warms.
- Run several minutes before applying a load.
Specs & values
- Do not crank more than 15 seconds; allow 1 minute cooldown
Source: Hercules service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.